Bagan Torsi Roda

Proper wheel installation requires tightening the wheel-attaching hardware (lug nuts or bolts) to the recommended torque specification for the vehicle make, model, and year. You can usually find torque specifications in the vehicle’s owner’s manual. Proper torque requires the correct tools, procedures, and patterns. This prevents over-tightening the hardware, stripping the fastener threads, and stretching the studs. It will also reduce the possibility of warping the brake drums, rotors, or hubs.

Ing- utawa over-tightening wheel-masang hardware bisa ngrusak lan mbebayani.

Torque specifications are for dry threads only. The fastener threads should be free of oil, dirt, grit, corrosion, etc. The hardware should turn freely without binding when tightened by hand. Do NOT lubricate hardware threads or seats. The friction against which torque is measured should come from the hardware seats. Lubricating hardware threads and seats alters the friction at the lug seat, leading to inaccurate torque readings and/or over-torquing of the hardware.

Sawetara variabel sing bisa nyebabake pangiriman torsi sing ora akurat:

• Jinis impact sing digunakake (udara, listrik, tanpa kabel)
• Daya (tekanan udara, volume udara, dawa selang, ukuran fitting, daya baterei, umur baterei)
• Dampak saben detik
• Ukuran palu internal
• Bisa nggunakake adaptor tambahan
• Ukuran soket, bobot, dawa
• Kekuwatan grip operator
• Bobot saka impact
• Sudut Applied nalika nggunakake

Attempting to tighten hardware with impact guns/torque sticks also prevents you from using a click-type torque wrench to confirm the specified torque is present. While a click-type torque wrench can identify when you reach the selected torque, it cannot detect excessive torque. Once you have the right tools, use the appropriate crisscross sequence (patterns shown below) for the number of wheel-attaching hardware positions until all reach their specified torque value.

Pola Tightening lan Loosening

Please re-torque the new wheels after the first 50 to 100 driving miles.

Do this if clamping loads have changed after the initial installation due to metal compression/elongation or thermal stresses as the wheels break in, and to verify the accuracy of the original installation.

If you plan to install a wheel on your vehicle, you must know the manufacturer’s recommended torque settings. Appropriate torque helps ensure the wheel assembly is securely installed. Using the manufacturer-recommended torque also helps ensure there isn’t too much or too little pressure on any of the assemblies to which the wheel attaches. Before you install your wheels, check your vehicle’s recommended torque.

• Ft-lb (Foot-Pound): Unit Imperial, standar ing AS.
• Nm (Newton-Meter): Unit metrik (SI), digunakake sacara global.
• Faktor Konversi: Kalikan ft-lb karo 1.356 kanggo entuk Nm, utawa bagi Nm karo 1.356 (utawa kalikan karo ~0.74) kanggo entuk ft-lb. 

• 10 ft-lb = 13.56 Nm
• 50 Nm = ~36.88 ft-lb
• 100 Nm = ~73.75 ft-lb